The Venturers - Yamaha Venture Technical Support Library

Not a member? Join Today to see why so many say they are Proud to be a Venturer!

Library Home Page > 1st Generation (1983 to 1993) > Electrical

83~85 Venture Stator Cooling Kit

  Author: Neil86 / TAC
  Views: 8580     Votes: 4
  Print

Early models (83-85) of the Venture originally had stator failures due to heat. Yamaha designed a "Stator Coil Oil Cooling Kit" (Part # 90891-30014) to provide an oil spray onto the windings to remove heat. The kit contains a rotor bolt that is drilled out through the center, a slinger in the bolt hole and plates to direct the oil back onto the stator as it is slung out of the bolt.
Yamaha did release a Tech bulletin and many were upgraded, but if you have a 83-85....check to see if it has the kit.....might save a future stator failure. If you remove the chrome cover (2 screws) from your stator cover you can see if the plate is there and if the bolt is drilled....If so, it already has the update kit.
The original bolt was not drilled.

The update was incorporated into production of the redesigned 1986 and later Venture 1300 models.

Contents of the kit.

Instruction diagram.

Last update: 10:28 PM Monday, June 20, 2011

All material on webpages under the domain venturers.org, is the property of The Venturers, Inc. These materials are protected by copyright and other intellectual property laws. You may not reproduce or retransmit the materials, in whole or in part, in any manner, without the prior written consent of The Venturers, Inc. The free information contained herein is offered in the spirit of helping others and any action or advice taken from these pages is the sole responsibility of the receiver.