The Venturers - Yamaha Venture Technical Support Library

Not a member? Join Today to see why so many say they are Proud to be a Venturer!

Library Home Page > 2nd Generation (1999 to current) > Performance

Acceleration Simulator

  Author: Archives
  Views: 8917     Votes: 3
  Print

Acceleration Simulator

The following default data is for a stock 1999 or 2000 Venture. You can fine tune the input parameters by typing over the default values and initiating another run. Have fun!

Engine

Max Engine Speed:

RPM

Torque (pound-feet)/RPM Pairs

	Torque	RPM
1
2
3
4
5

	Torque	RPM
6
7
8
9
10

	Torque	RPM
11
12
13
14
15

	Torque	RPM
16
17
18
19
20

	Rear Wheel Torque (drivetrain torque loss ignored)
	Normalized to ^oF and in Hg (SAE standard is 60^oF and 29.92 in Hg)

Drivetrain

Gear	1	2	3	4	5	6	Axle
Ratio (:1)

Note: Final drive ratio includes primary ratio of 1.776 and final ratio of 2.567

Drivetrain Torque Loss:

Chassis/Body

Race Weight:	lb	Weight on Rear Wheels:	% of Race Weight
Center of Gravity Height:	in	Wheelbase:	in
Coefficient of Drag:		Cross-Sectional Area:	ft²

Tires

Tire Diameter:

Coefficient of Rolling Friction:
Coefficient of Static Friction:

Environment

Temperature:

^o F

Barometric Pressure:

in Hg

Driving Style

Shift	Point (RPM)	Auto	Duration (ms)
1-2
2-3
3-4
4-5
5-6

Roll Out:	in
Launch:	RPM

Time
Delta
(ms)

Display
Delta
(ms)

Mode

Tower

5
10
25

100
250
500

1/8 mile
1/4 mile
Top speed

Summary Only

Auto Recall of Last Run

Notes:

Check Auto Recall of Last Run and all form settings and values as of your most recent "run" (after clicking the Go! button) will be automatically restored for you the next time you visit! For this to work, your browser must be configured to accept cookies.

Be sure to select the desired memory location before clicking one of the memory buttons (Recall, Store, Clear).

Launches are clutch-slipping with traction control, meaning RPM will stay at or above Launch RPM, and if torque to the rear wheels exceeds available traction, torque is reduced as much as is necessary to "prevent" wheelspin.

Inertial forces of the flywheel, engine reciprocating assembly, etc., during launch are ignored, mainly because I don't know how to correctly integrate them into my calculations.

Be patient after the results window pops up. This simulator (minus the form) is implemented entirely in client-side JavaScript (your computer executes it). On a 200 MHz Pentium running Netscape Navigator 3+, 1/4 mile results can take 5-10 seconds, while top speed results can take up to 30 seconds or so. Microshaft Exploiter may take 2 to 3 times longer.

Last update: 05:21 PM Sunday, September 26, 2004

All material on webpages under the domain venturers.org, is the property of The Venturers, Inc. These materials are protected by copyright and other intellectual property laws. You may not reproduce or retransmit the materials, in whole or in part, in any manner, without the prior written consent of The Venturers, Inc. The free information contained herein is offered in the spirit of helping others and any action or advice taken from these pages is the sole responsibility of the receiver.