royal star venture technical help

yamaha venture technical support

 

Not a member? Join Today to see why so many say they are Proud to be a Venturer!



Library Home Page > 2nd Generation (1999 to current) > Electrical
View Articles by Category:

No category found

Browse "Electrical" Articles
There are 25 articles found in this category:
Fuse Box Locations and ID
The Royal Star Venture has fuse boxes in three locations. Fuse Box \"A\" is located behind the right front lower cowling. To remove the cowling, remove the plastic retainer pin from ......
●●●●● Last Update: 2012-01-07 Views: 60436
Charging System Testing
The RSV charging system uses a permanent magnet type AC Magneto (ACM) alternator. The stator and rotor of the alternator are located inside the left engine cover. The rotor is attached to ......
●●●● Last Update: 2010-08-15 Views: 43723
Dash Light Bulbs
I had to split my fairing this morning to chase a short in my passing lamp wiring, which I did find and fixed. Anyway, my high beam indicator light had burned ......
●●● Last Update: 2010-04-04 Views: 10988
Carb Heater Info
The RSV is equipped with 4 electric carb heaters, one in each carb. These heaters draw 15 watts of power each, for a total of 60 watts. They are operated by a ......
●●● Last Update: 2007-11-25 Views: 10402
RSV Charging System Stator Upgrade
I finally got my hands on a stator that had more output than the OEM and so it was time to install it and see what we had. Here is the ......
●●●● Last Update: 2007-11-06 Views: 22846
Rebuilding the RSV Ignition Switch
Thought I would show a few shots of how the ignition switch is put together on these bikes. I know there has been a lot of posts in the past talking ......
●●●● Last Update: 2007-11-05 Views: 20148
Installing an LED Passing Light Indicator
Since I do not like to run my passing lights in the day,  I have installed an single 5mm LED (not a multiple LED array) in my dashboard to indicate if ......
●●●●● Last Update: 2007-03-12 Views: 10577
Factory Passing Lamp Instructions
 ...
●●●● Last Update: 2006-09-15 Views: 10889
Turn Signal Bulbs
Turn Signal Bulb Discussions 1157s - right?? Ponz Stock trade numbers are: 1157s front running/turn 1156s rear turns 1157 rear brake/running I don\'t have the info in front of me but ......
●●●● Last Update: 2006-09-14 Views: 10509
Faulty Ignition Switch - Temporary Repair
Faulty Ignition Switch Temporary Repair A few weeks back I stopped for gas, and when I turned the key on there was no electrical power, except for the radio. There was ......
●●●● Last Update: 2006-06-27 Views: 26367
LED light bar underneath the Trunk Rack
Installation of an LED light bar underneath the RSV Trunk Rack In our never ending quest for additional lighting on our Ventures, and after hearing a few fellow Venturers talking about ......
●●● Last Update: 2006-05-19 Views: 19422
Installing a Signal Dynamics BackOFF Brake Modulator
Q:  Hello there, I recently purchased the back off modulator and have a question about installing it. The directions say to connect one wire to ground, one wire to the brake ......
●●●●● Last Update: 2006-04-24 Views: 9027
Signal Dynamics Light Bar Install
We all know that the stock 99-05 Royal Star Ventures are lacking \"adequate\" rear brake and running lighting.  I am offering a simple and extremely easy and inexpensive solution.  I call ......
●●●●● Last Update: 2006-04-22 Views: 15833
Alternate Passing Light Installation
One of the most frequently asked questions is about passing light installation. Many Venturer members have installed their passing lights differently from how the Yamaha Passing Light instructions say to ......
●●●● Last Update: 2006-03-21 Views: 33215
How many accessories can I run?
I\'m impressed with the knowledge you guys have so I thought I\'d ask this: I have heated grips, heated vest, driving lights, tach, as well as a set of 55 watt ......
●●●●● Last Update: 2005-12-19 Views: 14638
Speed Sensor Test/Repair/Replacement
Speed Sensor Test/Repair/Replacementby Gary MaceApproved by The Venturers Technical Advisory Committee The RSV speedometer display is electronic. If the speed display becomes erradic or not working, it could be your speed ......
●●●●● Last Update: 2005-10-12 Views: 12751
Pilot Tail Lights
  Pilot Tail Lights How To Brighten Up Your Back EndOriginal Idea By Don Nelson - Additional Ideas By Dave Burgess The back end of the second generation Venture is in ......
●●●● Last Update: 2005-10-08 Views: 21005
Changing Reflectors to Lights
I have replaced the rear crash bar reflectors with a new LED light from JC Whitney: http://www.jcwhitney.com/autoparts/ItemBrowse/c-10111/s-10101/p-100000141759/mediaCode-ZX/appId-100000141759/Pr-p_CATENTRY_ID:100000141759 I got the idea from Kent (V7Goose) while at the SCR V ride in. ......
●●●●● Last Update: 2005-06-11 Views: 11789
Facts & Opinion on Resistor Plugs
A while ago, the topic of resistor plugs was brought up and questions arose to their purpose and why you would or would not use them in our machines. Anyways, I ......
Not Rated Last Update: 2005-05-21 Views: 6985
Installing Accessory Fuse Block
Q: I\'m installing a Power Plate from www.electricalconnection.com on my RSMV to power several accessories and lights. This is a six terminal power distrution block with independent fuses and a relay. ......
●●● Last Update: 2005-02-19 Views: 8963
LED Brake Light/Running Light Diagram
Okay a little help here guys, please! I need the wiring diagram on how to make the LED brake light into a running light and a brake. Some one else needs ......
●●●● Last Update: 2004-10-22 Views: 15463
Brighter Bulb Options
Replacing OEM Tail Light Bulb With a Halogen 1157Original Contribution by ButchJust a note for those of you considering making the back end of your new Venture a little brighter for ......
●●●● Last Update: 2004-10-08 Views: 21107
Taillight Assembly Drawing
...
●● Last Update: 2004-09-26 Views: 7859
Headlight Assembly Drawing
 ...
●●● Last Update: 2004-09-26 Views: 9428
Trailer Wiring
  Trailer Light Wiring Contributed by Norms99 Generally, a motorcycle with self cancelling signals and four way flashers, like the Venture, are not mechanical. Therefore, they will not work properly when ......
●●● Last Update: 2004-09-26 Views: 12559


Not a member? Join Today to see why so many say they are Proud to be a Venturer!

Copyright © 2000-2018 The Venturers, Inc.
All Rights Reserved
All material on webpages under the domain venturers.org, is the property of The Venturers, Inc. These materials are protected by copyright and other intellectual property laws. You may not reproduce or retransmit the materials, in whole or in part, in any manner, without the prior written consent of The Venturers, Inc. The free information contained herein is offered in the spirit of helping others and any action or advice taken from these pages is the sole responsibility of the receiver.