royal star venture technical help

yamaha venture technical support

 

Not a member? Join Today to see why so many say they are Proud to be a Venturer!



Library Home Page > 2nd Generation (1999 to current) > Engine
View Articles by Category:

No category found

Browse "Engine" Articles
There are 7 articles found in this category:
RSV Valve Adjusment Procedure
This article was submitted by member, ectswjoe, and covers the valve adjustment procedure for the Royal Star Venture. It is uploaded in it\'s original .pdf format and can be read in ......
Not Rated Last Update: 2013-05-05 Views: 19447
Replacing RSV Spark Plugs
To replace the RSV spark plugs, follow these steps: 1. Remove the drivers seat as shown in this article: http://www.venturers.org/Tech_Library/index.php?action=article&cat_id=002004&id=236 2. Remove the gas tank as shown here: http://www.venturers.org/Tech_Library/index.php?action=article&cat_id=002010&id=235 3. Remove ......
●●●● Last Update: 2006-09-01 Views: 25936
Plugging the AIS
  Plugging the AIS Taken from various posts in the discussion forum The AIS is used to control HC and CO emissions. Air is injected into the exhaust system to allow ......
●●●● Last Update: 2005-11-25 Views: 28212
Changing The Coolant
To start off I warmed up the bike for a few minutes to get the coolant flowing and try to stir up any junk that may be in the cooling system. The ......
Last Update: 2005-03-11 Views: 54090
Removing the AIS
  Removing the AIS by MM1006 The complete removal of the AIS system is fairly straightforward. Quite simply, remove all the components and plug the elbows at the exhaust ports. To ......
●●●●● Last Update: 2005-02-14 Views: 15889
Adding a Temperature Gauge
SHINDY/Daytona Coolant Temperature Gauge   The gauge itself is available from many sources but two of them areā€¦..   www.speedwerks.com  about $95   www.denniskirk.com about $100   It displays temperatures in either ......
●●●● Last Update: 2005-02-12 Views: 13175
Oil Change Tutorial
First off, round up a few of the essentials that you will need. 17mm wrench or socket Your favorite oil and filter Drain pan Funnel    Next step is to make ......
●●●● Last Update: 2005-02-08 Views: 51728


Not a member? Join Today to see why so many say they are Proud to be a Venturer!

Copyright © 2000-2018 The Venturers, Inc.
All Rights Reserved
All material on webpages under the domain venturers.org, is the property of The Venturers, Inc. These materials are protected by copyright and other intellectual property laws. You may not reproduce or retransmit the materials, in whole or in part, in any manner, without the prior written consent of The Venturers, Inc. The free information contained herein is offered in the spirit of helping others and any action or advice taken from these pages is the sole responsibility of the receiver.